SpeedyBee F405 Mini BLS 35A Stack

F405 Mini flight controller + 35A ESC with Bluetooth capability allowing you to wirelessly change settings and tune your stack.

Features:

• Wireless configuration FC + ESC BLHeli_S.
• 35A BLHeli_S DSHOT600 ESC
• Onboard 4-level battery life indicators
• 4 available UARTs
• Built-in barometer
• 5V 2A / 9V 3A dual BECs
• Onboard 8Mb blackbox storage
• Built-in Bluetooth BLE chip
• Works with M2 or M3 hardware

FC Specifications:

• MCU: STM32F722
• IMU (Gyro): ICM42688P
• USB Port: USB-C
• Barometer: Built-in
• OSD chip: AT7456E
• BLE Bluetooth: Supported (used for FC configuration) - Note that you cannot flash the FC or check Blackbox content wirelessly. Please make sure the MSP switch on UART 4 is turned on and set to a baud rate of 115200, otherwise Bluetooth functionality will not be available.
• DJI Air Unit Soldering pads available
• Blackbox: 8Mb
• Current Sensor: Supported, Scale = 250, Offset= -500
• Betaflight camera control pad: Yes (CC pad)
• Power Input: 3S-6S
• 5V output: 4 groups of 5V output, three +5V pads and 1 BZ+ pad( used for Buzzer) on front side. The total current load is 2A.
• 9V output: 1 group of 9V output, one +9V pad on front side. The total current load is 3A.
• 3.3V output: Supported. Up to 1A current load
• 4.5V output: Up to 500mA current load
• UARTs: 6 sets(UART1, UART2, UART3, UART4 (Dedicated for Bluetooth connection), UART5 (Dedicated for ESC telemetry), UART6
• ESC Telemetry: UART5
• I2C: Supported. DA & CL pads on front side. Used for magnetometer, sonar, etc..
• LED Pad: Used for WS2812 LED
• Buzzer: BZ+ and BZ- pad used for 5V buzzer
• BOOT Button: Used to enter DFU mode
• RSSI Input: Not supported
• SmartPort: Not supported
• Supported Flight Controller firmware: BetaFlight (default), INAV
• Firmware target: SPEEDYBEEF405MINI
• Mounting: 20x20mm, 3.5mm hole diameter compatible with M2 and M3 screws/silicone grommets
• Dimension: 30x32x7.8mm
• Weight: 9.6g

ESC Specifications:

• Firmware: BLHeli_S JH40
• Continuous Current: 35A * 4
• Burst current: 45A (5seconds)
• ESC Protocol: DSHOT300/600
• Power Input: 3-6S LiPo
• Power Output: VBAT
• Current Sensor: Supported (Scale=250, Offset= -500)
• Mounting: 20 x20mm, 3.5mm hole diameter compatible with M2 and M3 screws/silicone grommets
• Dimensions: 35 * 35 * 5.5mm
• Weight: 7.2g

Package:

• SpeedyBee F405 Mini flight stack
• Manual & APP download card
• XT30 pigtail (7cm)
• DJI 6-pin cable (80mm)
• 8pin JST cable (for your FC to ESC connection)
• 35V 470uF Capacitor
• M2 hardware
• M3 hardware

Manual here
Wiring diagram here

Write a review