SpeedyBee F7 Mini 35A V2 Stack

F7 Mini flight controller + 35A ESC with Bluetooth capability allowing you to wirelessly change settings and tune your stack.

Features:

• Wireless configuration FC + ESC BLHeli_S.
• 35A BLHeli_S DSHOT600 ESC
• Built-in Bluetooth 4.0 BLE chip
• Works with M2 or M3 hardware

FC Specifications:

• MCU: STM32F722
• IMU (Gyro): MPU6000
• USB Port: USB-C
• OSD chip: AT7456E
• BLE Bluetooth: Supported (used for FC configuration) - Note that you cannot flash the FC or check Blackbox content wirelessly.
• DJI Air Unit Soldering pads available
• Blackbox: 8Mb
• Current Sensor: Supported, Scale = 250, Offset= -500
• Betaflight camera control pad: Yes (CC pad)
• Power Input: 3S-6S
• 5V output: +5V pads available and 1 BZ+ pad (used for buzzer)
  Total current load is 2.5A
• 9V output: 2 groups of 9V output, the total current load is 2A
• 3.3V output: Supported. Up to 500mA current load
• 3.3V output: Up to 500mA current load
• UARTs: 3 UARTs available (1,2,3)
• ESC Telemetry: UART4
• LED Pad: Used for WS2812 LED
• Buzzer: BZ+ and BZ- pad used for 5V buzzer
• BOOT Button: Used to enter DFU mode
• RSSI Input: not supported
• SmartPort: Use any UART available for the SmartPort feature
• Supported Flight Controller firmware: BetaFlight (default), EMUFlight, INAV
• Firnware target: SPEEDYBEEF7MINIV2
• Mounting: 20x20mm, 3.5mm hole diameter
• Dimension: 30x30x7.5mm
• Weight: 5.7g

ESC Specifications:

• Firmware: BLHeli_S JH40
• Continuous Current: 35A * 4
• Burst current: 45A
• ESC Protocol: DSHOT300/600
• Power Input: 3-6S LiPo
• Power Output: VBAT
• Current Sensor: Supported (Scale=250, Offset= -500)
• Mounting: 20 x20mm, 3.6mm hole diameter
• Dimensions: 35 * 35 * 5.5mm
• Weight: 7g

Package:

• SpeedyBee F7 Mini flight stack
• Manual & APP download card
• XT30 pigtail (7cm)
• 8pin JST cable (for your FC to ESC connection)
• 35V 470uF Capacitor
• M2 hardware
• M3 hardware

Manual here
Wiring diagram here

Write a review