Silicone wire set - DJI FPV Air Unit 80mm

An alternative to those nasty stiff wires where the insulation retreats at the site of a soldering iron!

8pins with 6 wires (like the cable provided with the Air Unit)
Flexible silicone leads, 7.5cm (without connector) / 8cm (with connector) with JST-GH connector.

Note: This is not compatible with the DJI O3 Air Unit.

Color order:

• Red: Power (7.4V-17.6V)
• Black: Power ground
• White: UART RX (goes to TX on FC)
• Grey: UART TX (goes to RX on FC)
• Black: Signal ground
• Yellow: DJI HDL (goes to SBUS on FC)

Write a review