Matek PDB-Hex

PDB with high power BEC and capable of handling up to 12S, 140A continuously and with 30.5x30.5mm and 20x20mm mounting holes.

Note that you must use an insulating spacer under the PDB.

PDB:

• Input voltage range: 6~60V (2~12S LiPo)
• PDB/current sense resistor: 140A cont, 264A burst.
• ESC power pads: 60A cont. 100A burst
• 6x ESC power /signal/ telemetry pads
• Current Sensor: 264A,  3.3V ADC
• Current Scale 125(INAV/BF),  BATT_AMP_PERVLT  80 (ArduPilot)

JST-SH-8P Connector and Pads:

• Vbat: Battery voltage
• G: ground
• Curr: current signal
• Tlm: Duplicates Tlm pads for ESC telemetry
• S1/S2/S3/S4/S5/S6: ESC signal
• Vx: Regulator output

BEC Vx output (5V default):

• Vx= 5V by default,   Continuous 5 Amps
• Bridge 9V jumper,  Vx= 9V,  Continuous 4 Amps,  Max.5A
• Bridge 12V jumper,  Vx= 12V, Continuous 4 Amps,  Max.5A
• Output Short-circuit tolerant (1 seconds)
• Overcurrent protection & self-recovery

Voltage divider:

• 1K:20K resistors
• Output 1/21 Vbat voltage

Physical:

• Mounting: 30.5 x 30.5mm, 20 x 20mm, Φ3mm
• Dimensions: 49 x 40 x 6 mm
• Weight: 12g

Including:

• 1x PDB-HEX
• 1x Rubycon ZLJ 63V 390uF
• 1x JST-SH1.0_8pin cable, 5cm
• 2x JST-SH1.0_8pin connectors

Manual here

Write a review