Matek Flight Controller F722-STD

Matek Flight Controller F722-STD
Brand: Matek
Product Code: F722-STD
Availability: Out Of Stock
Price: USD$39.99
Qty:     - OR -   Add to Wish List
Add to Compare
0 reviews  0 reviews  |  Please Login To Review This Product

An F7 based board with 32k gyro - the bleeding edge!  Lots of info available from Matek here
Pair it with the FC-HUB6S for a super clean, minimal wiring setup.  A ribbon cable connects the two boards.


  •     MCU: 216MHz STM32F722RET6
  •     IMU: 32K ICM20602 gyro/accelerometer (SPI)
  •     Baro: BMP280 (I2C)
  •     OSD: BetaFlight OSD w/ AT7456E chip
  •     Blackbox: MicroSD card slot (SD/SDHC)
  •     VCP, UART1, UART2, UART3, UART4, UART5
  •     PPM/UART Shared: UART2-RX
  •     Battery Voltage Sensor: 1:10
  •     Current Sensor: No (FCHUB-6S, FCHUB-VTX option)
  •     BEC 5V: No (FCHUB-6S, FCHUB-VTX option)
  •     LDO 3.3V: Max.300mA
  •     I2C1 SDA & SCL: Yes
  •     Camera control: Yes
  •     DAC: Yes
  •     WS2812 Led Strip : Yes
  •     Beeper : Yes
  •     RSSI: Yes
  •     3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
  •     7x PWM / DShot outputs without conflict
  •     5x UARTs
  •     1x Group of G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
  •     1x I2C1
  •     4x pairs of corner pads for ESC Signal/GND connections (DSHOT compatible)
  •     1x Side-press button for BOOT(DFU) mode
  •     1x 16pin bottom mounted FFC Slot for FCHUB-6S or FCHUB-VTX connection


  •     36x36mm PCB with 30.5mm mounting holes
  •     w/ 2x 0.5mm*16Pin 5cm Flexible Flat Cable
  •     w/ 4pcs M3 Anti-vibration Standoffs

Wiring Guides here

Write a review

Please Login To Review This Product

Rotorgeeks © 2019
View Mobile / Standard