Matek ELRS 2.4GHz PWM 6Ch Rx

A 6 channel PWM 2.4GHz ELRS receiver.

Specifications:

• ESP8285, SX1281
• Antenna connector: IPEX MHF 1
• 6x PWM outputs
• Support 2~8S VBat voltage sense
• RF Frequency: 2.4GHz (2400~2480MHz)
• Telemetry power: 12dbm
• Receiver output protocol: PWM
• Input voltage: 4~9V DC @ “+” pad
• Voltage sense: 34V Max. @ “VBat” pad
• Power dissipation:  45mA(binding), 85mA(wifi mode)
• PCB size: 20mm x 18mm
• Weight: 2g w/ antenna

Firmwares:

• Generic targets used as a base 2.4 GHz  –> ExpressLRS 3.0 or newer, Generic ESP8285 6xPWM 2.4Ghz RX
• ExpressLRS wiki for PWM receiver, Click here
• Make sure Receiver and TX module both are running ExpressLRS 3.0 or newer

Notes: Receiver comes flashed with ExpressLRS 3.0 preloaded with the following binding phrase “123456”.  The Receiver will not get into binding mode if using the traditional binding procedure. You will need to reflash the Rx with your binding phrase OR go into WebUI to set your binding phrase.

Tips:

• Flashing via Wifi:
  • Disconnect ESC and servos from receiver first.
  • Power on receiver by 5V source. Receiver’s LED(Red) will blink slow at first, and after 20s, it should blink fast indicating it’s on Wifi Hotspot Mode.
  • More details here.
  • Target: DIY 2.4 GHz / DIY 2400 RX PWMP EX
• Flashing via UART:
  • Disconnect ESC and servos from receiver first.
  • Wire the receiver into the USB-TTL adapter, with TX on receiver connected to the Rx on the USB-TTL, and RX on receiver connected to the Tx of the USB-TTL. Wire 5V and GND of the USB-TTL to 5V and GND of the Receiver.
  • Press the boot button while powering on the receiver, then release – the Red LED on receiver should now be solid.
  • Select the target DIY 2.4 GHz / DIY 2400 RX PWMP EX and  “UART” for Flashing Method, set your bind phrase and Firmware Options and once done, click on Build and Flash.

Package:

• 1x ELRS-R24-P6
• 1x IPEX MHF1 Antennas. 15cm
• Dupont 2.54 pins  (Board is shipped unsoldered)

Write a review