Stack replacement for the iFlight Evoque.
Features:
- Improved circuit design with better components and less electrical noise!
- DJI HD VTX Connector (Plug-and-Play - no soldering required)
- FC indicator LEDs for visual debugging
FC Specifications:
- MCU: STM32 F722
- Gyro: BMI270
- Barometer: DPS310
- OSD Chip: AT7456
- Flash: 16MB (Blackbox flash)
- UARTS: 6
- Motor outputs: 4x (SH1.0 connector)
- I2C serial: SDA / SLA pads
- Smartaudio / IRC Tramp VTX protocol supported
- LED controller: Yes
- Beeper pad: Yes
- Firmware target: IFRC-IFLIGHT_BLITZ_F722
- Mount pattern: 20x20 mm / 4mm PCB hole diameter, silicon grommets for M3 screws
- Dimensions: 30.5x27 mm
- Weight: 5g
ESC Specification:
- Dimension: 35*42mm
- Mounting Holes: 20*20mm/Φ4mm
- Weight: 11.3g
- Supports 2-6S Lipo input
- MCU: G071
- Constant: 55 Amps
- Burst: 60 Amps
- Current sensor: Yes
- BEC: No
- Current rate: 100
- Supports: DShot DShot150/300/600/MultiShot/ OneShot etc.
- Firmware: BLHeli 32
- Target: IFLIGHT_BLITZ_G1
Wiring suggestion:
- UART 1 for VTX HD / Analog
- UART 2 for a Receiver
- UART 3/4/5 for GPS or other sensors that require a serial port
- UART 6 for ESC Telemetry
Package:
- 1pc BLITZ Mini F7 V1.1 Flight Controller
- 1pc BLITZ Mini E55 4-IN-1 2-6S ESC
- 1set silicon grommets
- 1set wire harness for F7 Flight controller
Wiring/Manual diagram here