iFlight Blitz Mini F7 E55 Flight Stack

Stack replacement for the iFlight Evoque.

Features:

• Improved circuit design with better components and less electrical noise!
• DJI HD VTX Connector (Plug-and-Play - no soldering required)
• FC indicator LEDs for visual debugging

FC Specifications:

• MCU: STM32 F722
• Gyro: BMI270
• Barometer: DPS310
• OSD Chip: AT7456
• Flash: 16MB (Blackbox flash)
• UARTS: 6
• Motor outputs: 4x (SH1.0 connector)
• I2C serial: SDA / SLA pads
• Smartaudio / IRC Tramp VTX protocol supported
• LED controller: Yes
• Beeper pad: Yes
• Firmware target: IFRC-IFLIGHT_BLITZ_F722
• Mount pattern: 20x20 mm / 4mm PCB hole diameter, silicon grommets for M3 screws
• Dimensions: 30.5x27 mm
• Weight: 5g

ESC Specification:

• Dimension: 35*42mm
• Mounting Holes: 20*20mm/Φ4mm
• Weight: 11.3g
• Supports 2-6S Lipo input
• MCU: G071
• Constant: 55 Amps
• Burst: 60 Amps
• Current sensor: Yes
• BEC: No
• Current rate: 100
• Supports: DShot DShot150/300/600/MultiShot/ OneShot etc.
• Firmware: BLHeli 32
• Target: IFLIGHT_BLITZ_G1

Wiring suggestion:

• UART 1 for VTX HD / Analog
• UART 2 for a Receiver
• UART 3/4/5 for GPS or other sensors that require a serial port
• UART 6 for ESC Telemetry

Package:

• 1pc BLITZ Mini F7 V1.1 Flight Controller
• 1pc BLITZ Mini E55 4-IN-1 2-6S ESC
• 1set silicon grommets
• 1set wire harness for F7 Flight controller

Wiring/Manual diagram here

Write a review