5-in-1 AIO flight controller using OpenVTX (up to 400mW), 12A ESC (BLHeli_S ESC), onboard FrSKY receiver (D8/D16), plugin connector for your motors and can take 1S or 2S batteries.
Notes: DO NOT FLASH THE BOARD WITH 4.3.1. There are SPI related issues when using 4.3.1. A fix is coming with a new firmware that will be available soon (4.3.2). STAY ON 4.3.0 OR BELOW.
Although D8 is still recomended, if using BF 4.3.0, you can now use D16 as well.
Notes: This is the V2 version capable of taking up to 2S.
Specifications:
- FC:
- Betaflight firmware target: CRAZYBEEF4FR
- MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
- Sensor: ICM42688P
- Mount hole size: 25.5mm*25.5mm
- Power supply: 1-2S battery input (DC 2.9V-8.7V)
- Built-in 12A (each) Blheli_S 4in1 ESC
- Built-in Betaflight OSD (SPI Control)
- Built-in 5.8G OpenVTX 0mw~400mw
- Built-in FrSKY D8/D16 Rx
- Built-in voltage meter sensor: voltage meter scale 110
- Built-in current meter sensor: current meter scale 470
- Weight: 5.1g
- 4in1 ESC:
- Power supply: 1-2S LiPo/LiPo HV
- Current: 12A continuous peak 15A (3 seconds)
- Supports BLHeliSuite
- Factory firmware: Z_H_30_REV16_7.HEX
- Default protocol: DSHOT300
- Supports Bluejay firmware
- When using Bluejay firmware with 48khz, set startup power to 1100/1200
- Receiver:
- SPI BUS receiver
- CC2500 RF
- Compatible with Non EU transmitter D8 model Channels: 8ch
- No ground interference ( Transmitter and receiver 1 m from the ground): 200meter failsafe supported
- Supports Frsky D8/ D16 , Redpine , SFHSS
- OpenVTX:
- Firmware version: OPENVTX
- Smartaudio v2.1
- PIT mode supported
- RACE mode supported
- Channels: 48ch
- Transmitting Power: 0/RACE/25mw/100mw/400mw
- Power supply: DC 5V
- Current (5v): <650ma (400mw)
- Antenna connector: U.FL
Package:
- 1x X12 AIO Board
- 1x Dipole UFL Antenna
- 1x Camera cable
- 1x PH2.0 Pigtail
- 1x set of screws and grommets
Wiring diagram here