HappyModel SuperBee F4 Lite Brushless AIO Flight Controller - ELRS

Ultra lightweight 1S AIO FC for the Moblite7 HD.

Specifications:

• FC:
  • SPI ELRS version Firmware target: CrazybeeF4SX1280
  • MCU:STM32F411CEU6 (100MHz, 512K FLASH)
  • Sensor: ICM42688P (SPI connection)
  • Power supply: 1S LiPo LiHV battery input (DC 2.8V~4.35V)
  • Built-in 5A (each) Blheli_S 4in1 ESC Dshot600 ready
  • Built-in Betaflight OSD (SPI Control)
  • Built-in SPI ExpressLRS receiver
  • Built-in 5V 1A BEC
  • Built-in voltage detection
• ESC:
  • MCU upgraded to EFM8BB21
  • Power supply: 1S LiPo/LiPo HV (2.8v~4.35v)
  • Currents: 5A continuous peak 6A (5 seconds)
  • Support BLHeliSuite programmable
  • Factory firmware: S_H_50_REV16_8.HEX
  • Default protocol: DSHOT150/DSHOT300/DSHOT600
• SPI ExpressLRS 2.4GHz Receiver
  • Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
  • RF Frequency: 2.4GHzAntenna plug: IPEX
  • Telemetry output Power: <12dBm
  • Receiver protocol:  SPI ExpressLRS
  • Could bind with ELRS V2.0 firmware TX module

Note:
This FC was originally designed to be used with FPV HD system so the original default device for the OSD is "MSP". If you use analog gear, connect to Betaflight, go to the CLI tab and enter:

set osd_displayport_device = MAX7456
save

You can then upload the OSD font.

Please note that all warranty claims are handled and approved by Happy Model only.  If you have any issues please contact them here

Write a review