Zeez 3030 F7 60A Flight Stack

30x30 stack for sull size frames with 60A 4-in-1 ESC and F7 processor.

Specifications:

FC:

• Mounting holes: 30×30
• Up to 8S input (max 36V)
• 5V BEC up to 3A continuous
• STM32F722 MCU (Support BetaFlight, EmuFlight, INav)
• MPU6000 Gyro/ACC for smooth performance
• 128MB Onboard flash
• OSD chip Onboard
• 6 available UART
• VTX switch to control the ON/OFF of the VTX directly from your transmitter
• LC Filter for 5V VTX
• USB Type C connector
• Onboard RGB LED distribution for clean wiring to the LED on the arm of the quad.
• Onboard RBG LED
• Notch design on sides and in the front of the FC for better fitting on the frame.
• Direct solder connection and board space for TBS Nano RX and TBS Unify Pro32 Nano providing the ultimate in clean stack installation.
• Logic Side and USB current protection

ESC:

• Mounting holes: 30×30
• Input: 3S to 6S
• High quality Mosfet: 60A continuous current draw /90A peak current
• Aluminum HeatSink to cooldown the Mosfet.
• BlHeli32 Firmware (support Dshot150/ Dhsot300 /Dshot600/ProShot 1000) and still compatible with all older analog protocol (OneShot42, OneShot125, Multishot)
• 8 Pin JST connector and 8 Pin solder pads
• Holes for Aluminum Low ESR capacitor (included 35V 470uF Low ESR capacitor and a spare capacitor)
• Onboard analog current sensor (Firmware Scale: 350)
• ESC telemetry to read RPM and ESC temperature
• Compatible with Bidirectional Dshot out of the box

Package:

• (1X) Zeez F7 Flight Controller
• (1X) Zeez 60A 4in1 ESC
• (8X) Aluminum Standoff
• (4X) Aluminum Nut
• (1X) ESC to Flight Controller 8 Pin to 8 Pin JST SH 1.00mm connector
• (1X) ESC to Flight Controller 8 Pin to Free wires (with JST SH crimp) JST SH 1.00mm connector
• (1X) ESC to Flight Controller 8 Pin to Servo Connector JST SH 1.00mm connector
• (1X) JST SH 8 Pin Plastic Housing
• (1X) JST SH 10 Pin Plastic Housing
• (2X) 470uF 35V Low ESR Capacitor
• (1X) XT60 with 12AWG Silicon Cable for battery connection
• (2X) 2.00mm Header Pin for VTX connection
• (2X) 2.54mm Header Pin for Receiver connection
• (4X) Spare M3 rubber anti vibration for Flight Controller or ESC

Manual here

Write a review