Aikon F7 DJI V3 35A Mini Flight Stack

The Aikon flight stack is packed with all the greatest features into one seamless flight experience. The flight controller has a direct plug for the DJI FPV Air Unit or Caddx Vista / Nebula Pro.

Note: Use the cable provided with the ESC packaging to connect your FC to ESC. ESC is flashed with the latest 32.8 firmware, make sure to have the latest BLHeli32 configurator.

Flight Controller:

Features:

• 216mhz F7 processor
• 5 invertable hardware UARTS
• Onboard OSD and blackbox
• Software controlled VTX power switch
• LED outputs
• Quick connection cable for 4-in-1 ESCs, works out of the box with the Aikon 4-in-1 ESCs
• On-board voltage regulator up to 6S
• Quick connection for DJI Digital FPV gear with a 10V 1.5A BEC

Specifications:

• Battery: 2-6s
• Mount Hole: 20*20mm
• Firmware: Betaflight AIKONF7 Target
• MCU: STM32F722
• IMU: BMI270
• Blackbox: SPI 16MB
• Weight: 8g

4-in-1 ESC:

Features:

• BLHeli_32 code base
• Programmable PWM frequency of up to 48KHz
• Auto-timing for higher efficiency and reliability
• Analog Voltage/Current sensing
• Adjustable “Brake on Stop” force
• Improve direction change in Bidirectional mode
• One current sensor to measure the total amp draw and telemetry functions.
• ESC Telemetry (Voltage and RPMs and current)
• Configuring from FC using DShot commands
• Programmable sine modulation mode
• Programmable soft bidirectional mode
• Programmable autonomous periodic (every 32ms) telemetry mode
• Hardware noise filter on the signal input

Specifications:

• Battery: 2-6s
• Constant Current: 35A
• Burst Current: 45A
• Mount Hole: 20*20mm
• Firmware: BLHeli32
• MCU: STM32PINF0
• Bootloader: Yes
• Weight: 10g w/o wires
• Signal wire length: 100mm
• Battery wire length: 100mm

Package:

FC:

• 1x Aikon F7 Mini FC
• 4x Grommets
• 2x Cable connectors for ESC to FC

ESC:

• 1x Aikon AK32PIN 4-in-1 35A 6S
• 1x XT60H pigtail
• 1x 1x capcitor 35V 330uF
• 4x grommets
• 1xCable connectors for ESC to FC

Wiring diagram here

Write a review