CL Racing Talon F7 Mini BB Flight Controller

CL Racing Talon F7 Mini BB Flight Controller
CL Racing Talon F7 Mini BB Flight Controller CL Racing Talon F7 Mini BB Flight Controller CL Racing Talon F7 Mini BB Flight Controller CL Racing Talon F7 Mini BB Flight Controller CL Racing Talon F7 Mini BB Flight Controller
Brand: CL Racing
Product Code: Talon F7 Mini
Availability: In Stock
Price: USD$32.99
Qty:     - OR -   Add to Wish List
Add to Compare
0 reviews  0 reviews  |  Please Login To Review This Product

A brand new generation of Talon is here: the Talon F7 Mini Flight Controller. With a F7 processor 8S capable and a blackbox, Talon is the only 20X20 on the market with a STM32F722RET6 216MHz processor.  Built in Betaflight OSD, 6 UARTS, and dedicated LDOs for cleaner gyro and OSD signals makes Talon F7 the most powerful 20X20 FC on the market. One of the features Talon F4 customers praised is the choice of using the 8 pin harness or direct soldering motor ports to the ESC. They have kept that option, while still adding even more features, by letting customers remove the plastic connector to reveal motor ports.

Specifications:

  • MCU: STM32F722RET6 216MHz
  • 6-Axis ICM20602 32K
  • Built in Betaflight OSD
  • Up to 8S (36V) direct battery power
  • Buzzer pads for external buzzer
  • Build in voltage monitoring resistor
  • 5V 2A BEC
  • Dedicated LDO for gyro for cleaner gyro signal
  • Dedicated LDO for OSD for cleaner OSD signal
  • Led strip shares 5V with 5V/2A BEC
  • 6 UARTS: UART1, UART2, UART3, UART4, UART5, UART6
  • Built in camera control pin with resistor and capacitor
  • 4 Full UARTS with RX/TX pins
  • Logical pin layout for cleanest build possible
  • 8 pin 4 IN 1 ESC plug (Direct solder motor ports underneath)
  • Remap able LED pad for additional motor output
  • TX3 & RX3 can be used for I2C for external compass
  • 5V or 3.3V selectable receiver power
  • 5V, VBAT selectable VTX and CAM power
  • Betaflight target: CLRACINGF7
    Note: If there is a delay in startup for the CLF7 target, type the commands below in the CLI to fix it:
    resource i2c_sda 2 none
    resource i2c_scl 2 none
    save

WARNING! If you remove the JST connector to direct solder, the pinout is not the same as the JST connector. Please check picure #6 (the last one) to see the correct pinout. Please pay attention to VBAT and Ground!

Package:

  • Pin connector (Aikon compatible)
  • 8 grommets
  • M3 to M2 nut adapters
  • M3X5 standoffs

Write a review

Please Login To Review This Product

Rotorgeeks © 2019
View Mobile / Standard