Holybro SiK Telemetry Radio V3 - 915MHz

This Holybro SiK Telemetry Radio is a small, light and inexpensive open source radio platform that typically allows ranges of better than 300m “out of the box” (the range can be extended to several kilometers with the use of a patch antenna on the ground). This radio is plug-n-play with all Pixhawk Standard and other Flight Controller, providing the easiest ways to setup a telemetry connection between your Autopilot and a ground station. It uses open source firmware which has been specially designed to work well with MAVLink packets and to be integrated with the Mission Planner, Ardupilot, QGroundControl, PX4 Autopilot.

This is the 915MHz 500mW version

Features:

• Open-source SIK firmware
• Plug-n-play for Pixhawk Standard Flight Controllers
• Easy way to connect your Autopilot and Ground Station
• Interchangeable air and ground radio
• Micro-USB port (Type-C Adapter, Cable Included)
• 6-pin JST-GH connector

Specifications:

• Frequency: 915MHz
• 500mW maximum output power (adjustable)
• RP-SMA connector
• 2-way full-duplex communication through adaptive TDM UART interface
• Transparent serial link
• MAVLink protocol framing
• Frequency Hopping Spread Spectrum (FHSS) Configurable duty cycle
• Error correction corrects up to 25% of bit errors Open-source SIK firmware
• Configurable through Mission Planner & APM Planner
• FT230X/FT231 is a USB to BASIC UART IC
• Dimensions: 28 x 53 x 10.7mm (without antenna)
• Electrical Data:
  • Supply voltage: 5V DC (from USB or JST-GH)
  • Transmit current: 100mA at 20dBm
  • Receive current: 25mA
  • Serial interface: 3.3V UART
• FCC IDENTIFIER: 2AP22-HT03-V3

Package:

• Radio modules with antennas *2
• Micro-USB to USB-A cable *1
• Micro-USB to Micro-USB OTG adapter cable *1
• Micro USB to Type C Adapter
• JST-GH-6P to JST-GH-6P cable *1 (for Pixhawk Standard FC)
• JST-GH-6P to Molex DF13 6P (for Pix32, Pixhawk 2.4.6, etc.)

Quick start guide here
Tips here

Write a review