Zeez 3030 F7 60A Flight Stack

Zeez 3030 F7 60A Flight Stack
Zeez 3030 F7 60A Flight Stack Zeez 3030 F7 60A Flight Stack
Brand: Zeez
Product Code: HP0152-0007
Availability: In Stock
Price: USD$94.99
Qty:     - OR -   Add to Wish List
Add to Compare
0 reviews  0 reviews  |  Please Login To Review This Product

30x30 stack for sull size frames with 60A 4-in-1 ESC and F7 processor.

Specifications:

FC:

  • Mounting holes: 30×30
  • Up to 8S input (max 36V)
  • 5V BEC up to 3A continuous
  • STM32F722 MCU (Support BetaFlight, EmuFlight, INav)
  • MPU6000 Gyro/ACC for smooth performance
  • 128MB Onboard flash
  • OSD chip Onboard
  • 6 available UART
  • VTX switch to control the ON/OFF of the VTX directly from your transmitter
  • LC Filter for 5V VTX
  • USB Type C connector
  • Onboard RGB LED distribution for clean wiring to the LED on the arm of the quad.
  • Onboard RBG LED
  • Notch design on sides and in the front of the FC for better fitting on the frame.
  • Direct solder connection and board space for TBS Nano RX and TBS Unify Pro32 Nano providing the ultimate in clean stack installation.
  • Logic Side and USB current protection

ESC:

  • Mounting holes: 30×30
  • Input: 3S to 6S
  • High quality Mosfet: 60A continuous current draw /90A peak current
  • Aluminum HeatSink to cooldown the Mosfet.
  • BlHeli32 Firmware (support Dshot150/ Dhsot300 /Dshot600/ProShot 1000) and still compatible with all older analog protocol (OneShot42, OneShot125, Multishot)
  • 8 Pin JST connector and 8 Pin solder pads
  • Holes for Aluminum Low ESR capacitor (included 35V 470uF Low ESR capacitor and a spare capacitor)
  • Onboard analog current sensor (Firmware Scale: 350)
  • ESC telemetry to read RPM and ESC temperature
  • Compatible with Bidirectional Dshot out of the box

Package:

  • (1X) Zeez F7 Flight Controller
  • (1X) Zeez 60A 4in1 ESC
  • (8X) Aluminum Standoff
  • (4X) Aluminum Nut
  • (1X) ESC to Flight Controller 8 Pin to 8 Pin JST SH 1.00mm connector
  • (1X) ESC to Flight Controller 8 Pin to Free wires (with JST SH crimp) JST SH 1.00mm connector
  • (1X) ESC to Flight Controller 8 Pin to Servo Connector JST SH 1.00mm connector
  • (1X) JST SH 8 Pin Plastic Housing
  • (1X) JST SH 10 Pin Plastic Housing
  • (2X) 470uF 35V Low ESR Capacitor
  • (1X) XT60 with 12AWG Silicon Cable for battery connection
  • (2X) 2.00mm Header Pin for VTX connection
  • (2X) 2.54mm Header Pin for Receiver connection
  • (4X) Spare M3 rubber anti vibration for Flight Controller or ESC

Manual here

Write a review

Please Login To Review This Product