This little BNF is a lot of fun and ideal first drone giving you speed and agility! It is super small, very light and loads of fun to fly around.
The frame was designed by fellow Canadian, Kevin Langlois AKA Tarkusx_FPV. The components have been carefully chosen and works seamlessly together.
Although it can be flown with 1 cell batteries, 2S is where the action is. We give you the choice to use 2x PH2.0 for a 1-2S or to use an XT30 for 2S only.
Pre-solder 2S PH2.0 pigtail: Select this option if you want us to install a PH2.0 connector for a 1S-2S set up (note that you will need to bridge one of the connector to make it 1S - part not provided)
Pre-solder XT30 pigtail: Select this option if you want us to install an XT30 connector for a 2S setup
Weight: 36.03g (without batteries and using XT30 pigtail)
Body thickness: 2.5mm
AIO FC: HappyModel CrazyBee X
HappyModel 1102 10000kv
Receiver: FrSKY SPI D8
Runcam Nano 3
Set the radio controller to FrSKY D8 Protocol
Connect the FC via USB or plug a battery in (the red LED will be flashing)
Press the bind button on the FLight controller (see below link to the diagram to see where it is) - once in bind mode the you should have a steady red LED.
Put your radio into bind mode
If the binding procedure was succesful, the LED should start flashing.
You can finish the configuration in BetaFlight.
Note: If you have a hard time connecting the USB cable to the FC, you can use this adapter.