TBS Tango 2 Module Bay Add-on

After-market mod to add a module bay to your Tango 2. Sticks to the back of your Tango 2 and plugs into the receptacle board of your Tango 2.

Installation:

• Install the FPC cable to the PCB.
• With the blue side facing up, lift the lock and slide the cable in then lock it down.
• Feed the cable through the bottom and place the PCB to the module bay.  
• Turn the module bay around to make sure everything fits accordingly.
• Close the case with the 2 screws provided
• Use a dremel, knife or solder tip to cut a small hole accoridng to the outline.
• Slide the flex PCB through the drilled case.
• Clean the back surface and tape the Tango 2 module bay down
• Install the FPC cable into the receptacle.
• Close the Tango2 case, and you're done!

Warning: The batch 1 of Tango 2 shipped without module bay capability. Please verify that there is a connector (in pictures above) before purchasing this add-on. Upgrade PCB's are available!
Also, whenever opening up your Tango 2 in future, you will need to open the module bay and release the flex PCB from the socket.

Specifications:

• "LITE" style module bay add-on for Tango 2
• Compatiible with TBS Tango 2 mainboard "V006H" and up

Write a review