Rotorgeeks Bluejay - BNF FrSKY

This little 2S BNF is a lot of fun and an ideal first drone giving you speed and agility!  It is super small, very light and loads of fun to fly around.
With a 2S 300-660mAh battery you get plenty of flight time to enjoy its range. The larger batteries provide longer flight time (5+ minutes).
The new X12 AIO flight control board comes with a higher power 400mW video transmitter and sleeved dipole antenna, giving amazing video range.

Notes:

Thanks to Nick Burns and Infinity Loops for reviewing our kit! We have made a few changes based on their feedback:

• The antenna holder on the canopy has been revised and will hold the antenna better than the previous version.
• We've added the option to include a buzzer with upgraded canopy.

Specifications:

• Weight: 36g (without batteries) - 38g with buzzer (without batteries)
• 2.5mm carbon fiber
• HappyModel X12 V2 AIO FC, 12A 1-2S ESC
• Receiver: FrSKY D8/D16
• OpenVTX: 25-400mW
• HappyModel 1102 10000kv motors
• Runcam Nano 3 camera
• XT30 connector
• m2x7mm prop screws

Binding procedure:

• Set the radio controller to FrSKY D8 Protocol
• Connect the FC to Betaflight via USB - the red and green LED at the bottom next to the USB and boot button will be flashing.
• Go to the receiver tab, make sure the receiver is set to "FrSKY D" and click on "Bind receiver" - once in bind mode the you should have a steady red LED.
• Put your radio into bind mode
• If the binding procedure was succesful, the red LED should start flashing.
• You can finish the configuration in BetaFlight.

Note: The FC comes flashed with 4.3, please use Betaflight Configurator 10.8 or up for configuration.

Recommended batteries (not included):

• 2S 300mAh XT30
• 2S 450mAh XT30
• 2S 530/550 XT30
• 2S 660mAh XT30

Package:

• 1x Rotorgeeks Bluejay -  FrSKY BNF
• 1x pack of Gemfan Hurricane 2023 3 Blade (2x sets - 4CW / 4CCW)
• 1x pack of M2x7mm screws

Wiring diagram here

Tips:
Using M2x7 prop screws to secure props to the motors will add 1.8g but help prevent broken motor shafts from hard impacts (included in package).

Our current PID tune
Betaflight diff dump here
Note that PID profile 1 is best for 2S 450-660mAh batteries and PID profile 2 works well with very light batteries in the 300-380mAh range
Nick Burns PIDs profile + rates here

Write a review