HappyModel Mobula6 2024 1S BNF - ELRS

An ultra light 1S brushless whoop.

Features:

• AIO Flight controller with Serial ELRS Receiver and 5.8G OpenVTX
• Only 17.7g
• Equipped with the lightest brushless motors-SE0702, only 1.46gram
• FX17-B 1/3 CMOS 800TVL camera
• Smooth and powerful
• Compatible with 1S Lipo/LIHV

Specifications:

• Wheelbase: 65mm
• Size: 81mm*81mm*37mm
• Weight: 17.7g
• Motors: SE0702 28000kv
• Propellers: 31mm props with 1mm shaft
• FC: SuperX ELRS AIO 5-IN-1 FC with motor plugs and serial Rx based receiver (ELRS V3)
• Built-in VTX: OpenVTX that can go up to 400mW
• On-board ESC: 5A continuous / 6A peak (3sec) with Bluejay firmware (v0.19.2)
• Camera: FX17-B

Package:

• 1x Mobula6 2024 BNF
• 1x Extra set of Gemfan 1208-3 31mm tri-blade propellers (2cw+2ccw)
• 1x Spare canopy
• 1x Screw driver
• 1x Propeller disassemble tool

Dump files:

• Mobula6 2024 factory firmware 4.4.0
• Dump file for Mobula6 2024 with Betaflight 4.4.0
• Mobula6 2024 Factory firmware 4.4.2
• Dump file for Mobula6 2024 with Betaflight 4.4.2

Notes:

The AIO flight controller comes with two type of Gyro sensor, one is BMI270 and another one is ICM42688P. If you flash the FC you will need to set the gyro as shown below:

• For the BMI270: set gyro orientation to CW0° and the update frequency to 3.2kHz, and for should set to be CW90°
• For the ICM42688P: set gyro orientation to CW90° and the update frequency to 8kHz, and for should set to be CW90°

Please note that warranty claims are handled and approved by Happy Model..  If you have any issues please contact them here

Write a review