Emax Babyhawk-R 3" 136mm PNP

Emax Babyhawk-R  3" 136mm PNP
Emax Babyhawk-R  3" 136mm PNP Emax Babyhawk-R  3" 136mm PNP
Brand: Emax
Product Code: Babyhawk-R (3") PNP
Availability: Out Of Stock
Price: USD$149.99
Qty:     - OR -   Add to Wish List
Add to Compare
0 reviews  0 reviews  |  Please Login To Review This Product

Introducing the Babyhawk R 136mm (3" propeller).  Just add a receiver and get flying!
For FrSKY users, we recommend the R-XSR which can give telemetry and use LUA scripts (the Emax BNF version does not come with a telemetry / LUA script capable receiver).  For telemetry connection options, see our note at the very bottom of this page.
For Spektrum users we recommend a Lemon satellite

Our recommended battery is the GNB 3S 550 for maximum agility or the 650 or 750 for extended flight time.
VTX comes locked - unlocking procedure here

Please note that warranty support for this product is provided by Emax.



  • High Speed power system featuring RS1106 and the 3 inch propeller
  • FC/ESC AIO - Mini Magnum Tower
  • 136mm Carbon Fiber Frame
  • Only weighs 86.4g grams
  • Customizable Shell Canopy with adjustable camera positions
  • Pre-tuned Betaflight Firmware for optimized flight performance
  • OSD integrated with Low-Voltage detection
  • 40 Channel 5.8g VTX switchable 25/200mw
  • Compatible with EMAX Transmitter/Goggles/Accessories
  • Utilizes Micro CCD Sensor Camera
  • Accepts 3-4 cell LiPo batteries

Product list:

  1. BabyHawk  Race × 1  (PNP)
  2. Manual ×1
  3. 3 inch propeller propeller ×2
  4. Screw pack ×1
  5. Camera adjusting board ×1

Telemetry Connection Options

Option 1  Connect as shown in the picture in the gallery.  On the Ports page set Telemetry output to SmartPort for UART2 and enable Telemetry on the configuration page.

Option 2  Connect telemetry to the LED pin and use the following CLI commands to reassign it.

resource led_strip 1 none
resource serial_tx 11 A08

On the Configuration tab, enable Soft Serial
On the Ports tab, find Soft Serial 1 and enable SmartPort in the telemetry column

make sure tlm_halfduplex = on
If you wired the hacked signal, then in CLI type set tlm_inverted = on

Write a review

Please Login To Review This Product

Rotorgeeks © 2019
View Mobile / Standard