Hobbywing XRotor Micro Combo 45A 4in1 ESC + FC F4 (G2)

Hobbywing XRotor Micro Combo 45A 4in1 ESC + FC F4 (G2)
Hobbywing XRotor Micro Combo 45A 4in1 ESC + FC F4 (G2) Hobbywing XRotor Micro Combo 45A 4in1 ESC + FC F4 (G2) Hobbywing XRotor Micro Combo 45A 4in1 ESC + FC F4 (G2) Hobbywing XRotor Micro Combo 45A 4in1 ESC + FC F4 (G2)
Brand: Hobbywing
Product Code: 38040300
Availability: In Stock
Price: USD$99.99
Qty:     - OR -   Add to Wish List
Add to Compare
0 reviews  0 reviews  |  Please Login To Review This Product

Features:

XRotor Flight Controller F4 G2 w/OSD for FPV Racing:

  • Redesign every aspect:
    STM32 F405 MCU allows the FC to run the PID looptime and gyro with higher frequency.
  • The SPI ICM-20602 which integrates accelerometer and gyro (with the running frequency can be set to 32KHz) is adopted.
  • Onboard OSD microchip which supports the DMA mode allows users to adjust its parameters via the Betaflight software. (Note: the OSD is controlled by the F4 MCU.)
  • The FC which supports Betaflight firmware & allows parameter adjustment via Betaflight software is more applicable to FPV race.
  • F-card which can record and save more flight/black box data allows users to adjust thesetup of their aircraft easily.
  • Compatible with various receivers like SBUS, SUMH, SUMD, SPEKTRUM1024/2048, XBUS, PPM and etc.
  • LED strip signal output port allows users to adjust the color & flash mode of the LED strip via the FC.
  • Volt/Amp monitoring port allows users to check the battery voltage (BAT port) and current (CRT port , extra current meter is needed).
  • Buzzer output port allows users to connect external buzzer(s) to the FC for warning or informing the flight status of the aircraft.
  • Micro USB port allows users to connect the FC to a PC to flash firmware and adjust parameters.

XRotor Micro 45A 4in1 ESC BLHeli32 Dshot1200 3-6S:

  • High performance 32-bit microprocessor with the running frequency of up to 48MHz for excellent performance.
  • BLHeli_32 firmware is the third generation BLHeli, following base BLHeli and BLHeli-S.
  • All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling.
  • The code supports features to prevent sync loss. There are tunable parameters that can make the code run well even in the most demanding situations, although default settings will work excellently in normal operating environments.
  • The code supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us) and Multishot (5-25us).
  • Dshot signaling is supported at any rate up to at least Dshot1200. The input signal is automatically detected by the ESC upon power up.
  • The code also supports a beacon functionality, where the ESC will start beeping after a given time of zero throttle. This can be very useful for finding lost crafts.
  • On board 10V &5V BEC , powering different accessories such as FC , VTX ,Camera and LED lights and etc.

Specifications:

XRotor Flight Controller F4 G2 w/OSD for FPV Racing:

Application FPVs with 130-300mm FPVs Diagonal Wheelbase
Firmware OMNIBUSF4SD
FC Programming supported
Programming via Betaflight/Cleanflight-configurator or Others
Compatible with (Modes) PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, DShot1200, Proshot1000 and etc.
Compatible with (Transmitters) PPM, Spektrum, SBUS, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL, and etc.
OSD Buit-in
Voltage Monitoring Supported
Current Monitoring Supported
External Buzzer Supported
LED Control Supported
USB Port MicroUSB
Timing Supported
Motor Rotation Supported
size/ weight 36*36mm / 6g


XRotor Micro 45A 4in1 ESC BLHeli32 Dshot1200 3-6S:

Application

FPVs with 130-280mm Diagonal Wheelbase
LiPo Power input 3S-6S
Cont.Current 45Ax4
Burst Current 60Ax4
BEC Output [email protected] / [email protected]
Input wires 12AWG-130mm* (Red/Black)
Output Wire No wires but solder tabs
Connectors (In/Out) XT60 (w/ Wires Soldered on) /no
Weight / Size 11.5g / 32.7x18.4x6.2mm
Mounting holes 30.5x30.5mm
Throttle Calibration Supported
ESC Programming BLHeliSuite32
DEO Supported
OneShot Mode Supported
Timing Supported
Motor Rotation Supported

* Note: All the wire length above is the original length, not the length you see from the outside.

For all applications, please note the following:
1. Power capacitor must be installed.  Every Xrotor 45amp 4-1 includes 2 power capacitors. One larger, and one smaller.   The larger capacitor should be used for 5s-6s lipo, the smaller capacitor can be installed for 4s-5s lipo directly on the PCB (ESC), not by a power plug.  Failure to use the included power capacitors will result in damage to your ESC.

2. BL_Heli_32 ESC settings can cause damage. Default settings should be used.

3. Motor KV ratings and prop size/pitch combinations recommendations.

  • 4s Lipo using 5 inch props up to 2700KV
  • 5s using 5 inch props, up to 2450 KV
  • 6s using 5 inch props up to 1750 KV

Manual for FC here
Manual for ESC here
 

Write a review

Please Login To Review This Product

Rotorgeeks © 2019
View Mobile / Standard