CL Racing Talon F7 V2 MPU6000 Flight Controller

CL Racing Talon F7 V2 MPU6000 Flight Controller
CL Racing Talon F7 V2 MPU6000 Flight Controller CL Racing Talon F7 V2 MPU6000 Flight Controller
Brand: CL Racing
Product Code: Talon F7 V2 MPU6000
Availability: In Stock
Price: CAD$46.19
Qty:     - OR -   Add to Wish List
Add to Compare
0 reviews  0 reviews  |  Please Login To Review This Product

The newest version of the Talon F7 rolls back to the reliable MPU6000 IMU. With an F7 processor, 8S capability and blackbox, Talon is the only 20X20 on the market with a STM32F722RET6 216MHz processor.  Built in Betaflight OSD, 6 UARTS, and dedicated LDOs for cleaner gyro and OSD signals makes the Talon F7 one of the most powerful 20X20 FC on the market. One of the features Talon F4 customers praised is the choice of using the 8 pin harness or direct soldering motor ports to the ESC. They have kept that option, while still adding even more features, by letting customers remove the plastic connector to reveal motor ports.

If Motor 4 does not work copy-paste the following into the CLI. 

Resource MOTOR 6 None
Resource MOTOR 4 C08

To enable power to the VTX/CAM power pads, setup a mode switch for vtx_pit.  If you don't want to use the pit mode feature, enable it for the full range on any aux channel.

If you want to use Betaflight 3.5.7 you can download this hex file that will fix the motor 4 issue.  You should be using Betaflight configurator 10.4 for this firmware (scrolll down on the link).  If you are using the onboard

VTX and CAM power pads
You'll need to enter the following CLI commands
and configure Pit Mode as mentioned above.
Resource pinio 1 A14
Set pinio_box = 39

Voltage scale should be set to 160



  • MCU: STM32F722RET6 216MH
  • Proven noise free MPU6000
  • Buily in Betaflight OSD
  • Up to 8S (36V) direct battery power
  • Buzzer pads for external buzzer
  • Built in voltage monitoring resistor
  • 5V 2A BEC
  • Dedicated LDO for Gyro, noise free gyro power
  • Dedicated LDO for OSD, cleaner OSD signal
  • Led strip shares 5V with 5V/2A BEC
  • Built in camera control pin with resistor and capacitor
  • 5 Full UARTS with RX AND TX pins
  • Logical pin layout for cleanest build possible
  • 8 pin 4 IN 1 ESC plug
  • Remappable LED pad for additional motor output
  • TX3,RX3 can be used for I2C for external compass
  • 5V, VBAT selectable VTX and CAM power
  • 16M Blackbox flash chip
  • No flicker VTX pit mode switch (positive switch)
  • M4 Can be selected either led_strip signal or M4 signal for RPM filtering
  • 20 X 20 mounting hole with true 25mm board dimensions

FC manual here

Write a review

Please Login To Review This Product

Rotorgeeks © 2021
View Mobile / Standard