HappyModel X12 Pro V1.1 1-2S Brushless AIO Flight Controller - ELRS

The Pro version of the 5-in-1 AIO flight controller using OpenVTX (up to 400mW), 12A ESC (BLHeli_S ESC), onboard ELRS receiver (UART instead of SPI), plugin connector for your motors and can take 1S or 2S batteries.

Specifications:

• FC:
  • MCU:STM32F411CEU6 (100MHZ, 512K FLASH) ,ESP32-PICO-D4
  • Sensor: ICM42688 P(SPI connection)
  • Mount hole size: 25.5mm*25.5mm
  • Power input: 1-2S battery input (DC 2.9V-8.7V)
  • Built-in Betaflight OSD (SPI Control)
  • Built-in voltage meter sensor , voltage meter scale 110
  • Built-in current meter sensor , current meter scale 470
     
• 4in1 ESC:
  • Power supply: 1-2S LiPo/LiPo HV
  • Current: 12A continuous peak 15A (3 seconds)
  • Supports BLHeliSuite
  • Factory firmware: Bluejay v0.19.2
  • Default protocol: DSHOT300
  • When using Bluejay firmware with 48khz, set startup power to 1100/1200 (max)
     
• Receiver:
  • Packet Rate option: 50Hz/150Hz/250Hz/500Hz
  • ExpressLRS Firmware version: V3.0
  • RF Frequency: 2.4GHz
  • Antenna: SMD antenna
  • Telemetry output Power: <12dBm
  • Receiver protocol: Serial_based CRSF
  • Compatible with ExpressLRS V3.x.x TX Module
  • Cna upgrade firmware via WIFI
  • ExpressLRS firmware target:
    HappyModel AIO 2.4GHz RX+VTX (ExpressLRS web flasher)
  • Available from Expresslrs version 3.4.0 RC2
     
• OpenVTX:
  • Firmware version: OPENVTX
  • MSP VTX
  • PIT Mode support
  • Channels:40ch
  • Transmitting Power: 0/RCE/25mw/100mw/400mw
  • Power supply: DC 5V
  • Current (5v): <650ma (400mw)
  • Antenna connector: U.FL

Package:

• 1x X12 AIO FC
• 1x UFL Dipole 5.8GHz antenna
• 1x XT30 pigtail
• 1x PH2.0 connector
• 1x hardware kit

Please note that all warranty claims are handled and approved by HappyModel only.  If you have any issues please contact them here

Write a review