BetaFPV F722 2-6S AIO Brushless Flight Controller 35A (BLHeli_S)

F722 2-6S AIO 35A FC caapble of handling 6S batteries, compatible with Analog and HD Digital gear (comes with a direct plug for the Digital HD system), F722 processor with MPU6000, 35A ESC (BLHeliS).

Features:

• Direct plug for DJI Digital FPV System.
• 6 full UARTs are available on this board.
• Handles 35A continuous current (40A burst).

FC Specification:

• Weight: 7.06g
• CPU: STM32F722RET6
• Six-Axis: MPU6000 (SPI connection)
• Mounting hole size: 26mm * 26mm
• Firmware version: betaflight_4.2.x_BETAFPVF722
• OSD: Built-in BetaFlight OSD (OSD chip: AT7456E)
• Support programmable LED like WS2812 etc
• Built-in current sensor

ESC Specification:

• Signal support: PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
• Receiver: Support Frsky XM/XM+ Receiver/ Futaba Receiver/Flysky Receiver/DSMX Receiver/TBS Crossfire Receiver (requires external connection - receiver not included)
• Input voltage: 2S-6S Lipo
• Continuous current: 35A
• Peak current: 40A
• ESC firmware: BLHeli_S
• LED Indicators: 2 indicators:
  • receiver indicator (green)
  • Flight control power indicator (red)
• Capacitor: CS|5*10*13mm|470μF|35V
• Connector: 80mm 14AWG silicone cable with XT60

LED Indicator:

Package:

• 1 * Toothpick F722 35A AIO 2-6S brushless flight controller
• 1 * Cable Pigtail (XT60U)
• 1 * Capacitance
• 1 * 6-Pin Connector for DJI Digital VTX
• 4 * M2x10mm Screws
• 8 * M2 Nuts

Wiring diagram here
Wiring for Rx: Crossfire, Spektrum DSMX, FrSKY SBUS, Digital (using DJI remote V1 controller)

Write a review